Advertisement
HOW TO INSTALL THE UNIT
CAUTION
!
There are sharp edges that can cause serious cuts.
When lifting the air conditioner
people to lift.
- For existing sleeve, you should measure the wall
sleeve dimensions.
- Install the new air conditioner according to these
installation instructions to achieve the best performance.
All wall sleeves used to mount the new air conditioner
must be in good structural condition and have a rear
grille that securely attaches to the sleeve or the flange
of the sleeve to secure the new air conditioner.
- To avoid vibration and noise, make sure the unit is
installed securely and firmly.
- When installing the sleeve, make certain there is
nothing within 20 of the back that would interfere
with heat radiation and exhaust airflow. (See Fig.2)
COOLED
AIR
INTAKE
AIR
PREPARATION OF SLEEVE ASSEMBL
- Refer to the installation instruction of sleeve assembly
for details.
PREPARATION OF REAR GRILLE ASSEMBLY (optional)
- Refer to the installation instruction of rear grille
assembly for details.
UNIT INSTALLATION
- Carefully remove shipping tapes from the front panel.
(See Fig.3)
- Remove the front panel. (See Fig.4)
- Remove the shipping screw from the vent door
Fig.5)
INSTALLATION
, it is HEA
VY
. Use 2
SLEEVE
WALL
HEAT
RADIATION
Over 20
WALL
Fig.2
Y (optional)
. (See
Dimension of air conditioner
1067mm/42inch
408mm/16inch
606mm/23.9inch
Dimension of sleeve assembly (optional)
1067mm/42inch
408mm/16inch
376mm/14.8inch
Shipping
tape
- Pull out at the bottom to release it from the tabs
- Then lift up
.
2
11
Fig.3
2
1
Fig.4
Shipping
screw
Fig.5
.
1
Hide quick links:
Advertisement
