Setting The Saw Blade Depth - North Star 49157 Owner's Manual

Setting the Saw Blade Depth

Check that the cutter engine is turned off before making adjustments to the cutter to avoid an
accidental start and possible injury.
Use the procedure below to adjust the gauge pin correctly to zero depth (ground level). Once the pin
is set, an accurate depth reading can be obtained when cutting concrete.
1. Check that the saw blade is off the ground then put the concrete cutter on a level surface for this
procedure.
2. Turn the height adjust handle counter-clockwise to lower the Saw Blade until it just touches the
ground.
3. Loosen the right wheel nut.
4. Move the black Gauge Pin to zero (0) on the scale as shown below.
5. Retighten the wheel nut.
Page 17 of 30