Sony MVS-8000 User Manual page 266

7
Test firing the trigger
To test fire the trigger, press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the
trigger type is "Status."
Enabling or disabling Aux bus control
Use the following procedure.
1
2
3
4
5
266
Setup Relating to Switcher Processor
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
In the Switcher>Device Interface menu, press [Aux Control].
The Aux Control menu appears.
Select the 9-pin port for the setting, from the <Control> group.
Remote1: Make the settings for the REMOTE1 port.
Remote2: Make the settings for the REMOTE2 port.
Remote3: Make the settings for the REMOTE3 port.
Remote4: Make the settings for the REMOTE4 port.
Using any of the following methods, select the Aux bus.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
Knob Parameter Adjustment
1 No Aux bus selection
a) 0: EDIT PVW
1 to 48: Aux1 to Aux48
Select whether to enable or disable Aux bus control from the <Control
Mode> group.
Enable: enable control of the port selected in step 2.
Disable: disable control of the port selected in step 2.
Manual: make whether control of the port selected in step 2 is possible or
not depend on the setting in the Misc menu.
Repeat steps 2 to 4 as required to make the settings for other ports.
Setting values
a)
0 to 48