Table of Contents
Advertisement
4 INSTALLATION
4.1
Chassis Installation
Warning: Never install equipment in a wet location or during a lightning storm.
This section provides the procedures necessary for installing and cabling the RF Worx SignalOn
Series Chassis in a 19-inch equipment rack. Optional extension brackets are available for
installation in 23-inch rack applications.
Use the following procedure to install chassis in a 19-inch network rack, or equivalent.
1. Obtain a Flat blade or Phillips screwdriver (type to match mounting screws).
2. Place the chassis in the assigned mounting space and align the holes in the mounting
brackets with the holes in the equipment rack. See
3. Secure mounting brackets to the equipment rack using the 12-24 x 0.5-inch binder head
machine screws provided. Torque these screws to approximately 27 pound-inches (3.1
Newton meters).
4. Install power supply strip/kit following the installation drawing provided. Power strip/kit
is affixed to the rear of the chassis.
12-24 x 0.5 IN. SCREWS
(4 PLACES)
Figure 9. Installing 2RU Chassis in Rack
ADCP-61-825 • Issue 2 • December 2004
Figure 10
or
Figure
9.
20060-A
© 2004, ADC Telecommunications, Inc.
Page 9
Advertisement
Table of Contents
