Table of Contents
Advertisement
This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
3.1
Main body (Used model: NX-PB10E)
3.1.1 Removing the Rear cover (See Fig.1, 2, 3)
(1) Remove the three screws A, three screws B and two
screws C attaching the Rear cabinet. (See Fig.1)
B
C
A
B
(2) Disconnect the antenna wire from post pin
board. (See Fig.2)
(3) Disconnect the connector wire from Trans board connect-
ed to connector
CN402
1-6 (No.MB730<Rev.001>)
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
SECTION 3
DISASSEMBLY
C
A
Fig.1
FM1
of the Main
FM1
Fig.2
of the Main board. (See Fig.3)
CN402
Fig.3
3.1.2 Removing the Main board (See Fig.4)
(1) Disconnect the card wire from iPod board connected to
connector
CN103
(2) Disconnect the card wire from Key board connected to con-
A
nector
CN701
(3) Disconnect the connector wire from Left speaker connect-
ed to connector
(4) Disconnect the connector wire from Right speaker con-
nected to connector
(5) Disconnect the connector wire from Door switch board con-
nected to connector
(6) Disconnect the connector wires from USB board connect-
ed to connectors J13,
board.
(7) Disconnect the card wire from USB board connected to
connector
CN607
(8) Disconnect the connector wire from Door motor connected
to connector
B
(9) Disconnect the connector wire from CD mechanism con-
nected to connector
(10) Disconnect the flexible wire from CD pickup connected to
connector
CN901
(11) Remove the six screws D attaching the Main board.
D
CN405
CN603
J13
CN607
of the Main board.
of the Main board.
J2
of the Main board.
J3
of the Main board.
CN405
of the Main board.
CN603
and
CN306
of the Main board.
CN404
of the Main board.
CN902
of the Main board.
of the Main board.
CN404
CN306
CN902
CN103
D
D
D
D
CN701
CN901
Fig.4
off the Main
J2
J3
D
Advertisement
Table of Contents
