Diagnostic Mode - Polaris Sportsman 9920775 Owner's Manual

FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center

Diagnostic Mode

Screen 5: Programmable service interval
The purpose of the programmable service interval is to provide the con-
sumer and dealer with a convenient reminder for routine maintenance.
When your vehicle leaves the factory, this feature is set at 50 hours. You
must enable the programmable service interval before it can be used.
Once the service interval mode is set with the hours when service is due,
the hours of actual engine operation are subtracted from the set hours
until 0 is reached. When the counter reaches 0, the wrench icon will
flash quickly for 5 seconds each time the vehicle is started as a reminder
that the periodic maintenance is due.
To set the hours, press and hold the mode/override button until the
wrench icon flashes. When it begins to flash, release the button. The set-
ting will increase by one hour each time the button is pressed. Pressing
and holding the button will allow the numbers to escalate much faster.
When the desired time increment is displayed, release the button and
wait for the wrench to stop flashing. When the wrench stops blinking,
your service hours are set.
NOTE:
If you scroll past the intended number, hold the button down until the
count turns over to 0. You can then reset the number.
If the service interval is enabled on your ATV and you wish to turn it
off, toggle to the service interval mode. Press and hold the mode button
for approximately 7 seconds until the word OFF appears in the Rider
Information Center.
Screen 6: Miles/Kilometers toggle
The display in the tripmeter and odometer can be changed to display
either kilometers or miles. The current display mode will be shown as
KM or MP. To change, hold in the mode button until the letters flash,
then press and release the button once. When the display stops flashing,
the mode has been set.
49