Polaris Scrambler 9921777 Owner's Manual page 67

MAINTENANCE
Lubrication Guide
Check and lubricate all components at the intervals outlined in the Peri-
odic Maintenance Chart beginning on page 59. Items not listed in the
chart should be lubricated at the General Lubrication interval. See page
111 for the part numbers of Polaris products.
The a-arms and lower control arms are lubricated at the factory, and no
additional lubrication will be needed. However, if these components are
subjected to severe use, grease zerks have been provided for additional
lubrication at the user's discretion.
Item
Engine Oil
Brake Fluid
Drive Chain(s)
Transmission Oil
Front Gearcase
Front Prop Shaft
Yoke
Front Hubs
Swing Arm
Bushings
Axle Housing
Ball Joint
Tie Rod Ends
64
Lube
PS-4 PLUS Performance
Synthetic 2W-50
DOT 4 Only
O-ring chain lube or SAE
80/90
AGL Synthetic Gearcase
Lube
ATV Angle Drive Fluid
Premium U-Joint Lube
Premium Hub Lube
Premium All Season
Grease
Premium All Season
Grease
Premium All Season
Grease
Method
See page 66.
See page 32.
Lubricate.
See page 70.
See page 72.
Grease fittings (3 pumps maximum)
every 500 miles (800 km), before long
periods of storage, or after pressure
washing or submerging.
Remove set screw in hubs. Rotate
wheels to 4 o'clock position. If lubricant
is not visible add more. Reinstall set
screw.
Locate fittings on swing arm and
grease with grease gun
Locate fitting on back side of struts and
grease with grease gun.
Lift boot, clean away dirt and grease,
apply fresh grease by hand and reas-
semble. Perform when suspension
action becomes stiff, or after washing.