Uid/Power/Sid Cable - HP ProLiant DL580 Gen9 Maintenance And Service Manual

Using a Torx T-10 screwdriver, remove the screws securing the bezel to the chassis, and then
5.
remove the assembly from the server.
Disconnect the cable from the bezel.
6.
To replace the component, reverse the removal procedure.

UID/power/SID cable

Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel (on page 28).
4.
Remove the processor memory drawer (on page 29).
5.
Remove the SPI board (on page 30).
6.
Removal and replacement procedures 39