Drive Belt Installation; Torque Stop - Polaris 600 IQ Touring Owner's Manual

Clutch System

Drive Belt Installation

1. Drop the drive belt over the drive
clutch and pull back the slack.
Tip: To ensure satisfactory belt life, install
belts so they operate in the same
direction of rotation by positioning the
identification numbers so that you
can read them. If required, separate
the sheaves as outlined in the belt
removal procedures.
2. Rotate the L-wrench counter-
clockwise to tighten the sheaves while working the belt to the outer
edge of the sheaves.
3. Remove the wrench.
4. Reinstall the side panel.
5. Close and secure the hood.

Torque Stop

Periodically check torque stop clearance.
With clutches in proper alignment, the
torque stop clearance should be .010I-
.030I (.25-.75 mm) from the engine case.
Adjust if necessary. Lock the jam nut.
MAINTENANCE
.010 -.030
I
(.25-.75 mm)
I
107