Polaris 600 EDGE Touring Owner's Manual page 58

Before Starting the Engine
n Hydraulic Brakes
Always check the following items for proper operation before starting
the engine.
Brake Lever Travel
Squeeze the brake lever. It
should move no closer to the
handgrip than 1/2I (1.3 cm).
A smaller distance indicates
low brake fluid level or air in
the hydraulic system. Refer to
the brake bleeding informa-
tion on page 105 or see your dealer for service.
NOTE: If the brake lever feels "spongy" when squeezed, check the
brake fluid level and condition. Add fluid as needed. See page
104.
WARNING
Continued use of "spongy" brakes may cause a complete loss of brakes,
which could result in serious injury or death. Always have the brakes serviced
at the first sign of sponginess.
n Mechanical Brakes
Always check the following items for proper operation before starting
the engine.
Brake Lever Travel
Firmly depress the brake lever.
Measure the distance (A)
between the lever and brake
block. The distance should be
no more than 3/4I (1.9 cm).
If the distance is greater than
this recommendation, the brake
cable must be adjusted.
PRE-RIDE INSPECTIONS
1/2 (1.3 cm)
I
3/4 (1.9 cm)
I
55