Motorola VC70N0 Quick Reference Manual page 13

VC70N_QRG_72-164687-01_English_October 16.fm Page 13 Tuesday, October 16, 2012 2:29 PM
Quick Reference Guide
is enough slack in the cable to accommodate movement without
putting tension on the cable.
• DO NOT wind a cable in and out of the mesh on a cage.
• On electric vehicles, take the power from as close to the battery as
possible, but not directly from the battery terminals, and not before
any main fuse.
• On gasoline, diesel or propane vehicles, take the power from as close
to the battery terminals as possible, and avoid using existing wiring.
• Ensure that all fuses are as close as possible to the power source.
Internal Combustion Engine Forklifts
• All power wiring must use the supplied power cable.
• Fuses:
one 3AB, 15A, 250V, FST BLO fuse - 9-60V DC
-
one 3AB, 6A, 250V, FST BLO fuse - 36-96V DC.
-
• Keep the path between the battery and the vehicle computer as short
as possible, and away from any part of the ignition high tension
system.
Ignition Switch
15A Fuse 9-60V DC
Vehicle
6A Fuse 36-96V DC
Battery
Important: If your vehicle is not equipped with
an ignition switch, connect the yellow wire
directly to the vehicle's positive source. Failure to
comply, will not enable the computer operation.
You can use your old VC5090 power cable. When employing this option,
use VC5090 Bridge Cable, PN 25-159553-01. You must also replace the
fuses on the red and black wires of the old cable with the new fuses
supplied with the bridge cable kit.
Power Cable
Yellow
25-15951-01
9-60V DC
Red 25-15951-02
36-96V DC
Black
VC70
13