Page 1
Indirect calorifier ITE - 400/500/600/750/1000 Installation, User and Service Manual Innovation has a name.
Page 2
Uw Installateur / Your Installer / votre installateur A.O. Smith Hoofdkantoor Europa, De Run 5305, 5503 LW Veldhoven www.aosmith.nl, 0800-AOSMITH (2676484) A.O. Smith UK, Unit B8 Amstrong Mall, Southwood Business Park, Farnborough, Hampshire GU14 0NR www.aosmith.co.uk A.O. Smith France, 14, allée Charles Pathé, 18000 Bourges...
Page 3
Liability A.O. Smith Water Products Company accepts no liability for claims from third parties arising from unauthorised use, use other than that stated in this manual, and use other than in accordance with the General Conditions registered at the Chamber of Commerce.
Water-side maintenance ..................15 Warranty ........................ 17 General warranty ....................17 Tank warranty ......................17 Conditions for installation and use ................17 Exclusions ....................... 18 Scope of warranty ....................18 Claims ........................18 Obligations of A.O. Smith ..................18 0312735_ITE_400-1000_EN_V1.0, 2017-09-25...
Technical specifications 1.1 Floor load Allow for the water heater's weight and the maximum floor load; refer to the table (1.6 "General specifications"). 1.2 Water composition The water heater is intended for heating drinking water. The drinking water must comply with the regulations governing drinking water for human consumption. The table gives an overview of the specifications.
Note These products can be installed as vented and unvented. This manual only discusses unvented installations. For information about vented installations please contact A.O. Smith. Installation Diagram Legend 1. pressure relief valve (mandatory if mains water pressure is too high) 3.
Page 12
2.2.2 Hot Water side See (B) in the installation diagram (2.1 "Installation diagram"). Note Insulating long hot water pipes prevents unnecessary energy loss. Optional: fit a temperature gauge (12) so you can check the temperature of the tap water. Fit the T&P valve (3). Fit a stop valve (11) in the hot water outlet pipe for servicing.
Filling and draining Note These products can be installed as vented and unvented. This manual only discusses unvented installations. For information about vented installations please contact A.O. Smith. Installation Diagram Legend 1. pressure relief valve (mandatory if mains water pressure is too high) 3.
3.2 Draining 1. Close the stop valve (4) between the cold water head tank and the cold water inlet (A). 2. Open the drain valve (9). 3. Bleed the water heater (or installation) so that it drains completely. Installation, Service and User Manual...
Maintenance Warning Maintenance may only be carried out by a competent person. At each service, the water heater undergoes maintenance on water side. The maintenance must be carried out in the following order. 1. Preparation for maintenance 2. Water-side maintenance 3.
Page 16
Work order: 1. Undo bolts from the cover. 2. Remove cover and the gasket. 3. Inspect the tank and remove the loose scale deposits and contamination. 4. If the scale cannot be removed by hand, descale the water heater with a descaling agent.
A.O. Smith shall offer to replace the defective water heater with an entirely new water heater of equivalent size and quality The warranty period given on the replacement water heater shall be equal to the remaining warranty period of the original water heater that was supplied.
A.O. Smith Water Products Company products. Inspection of the water heater as referred to in articles 1 and 2 shall take place in one of the laboratories of A.O. Smith. 5.7 Obligations of A.O.