Yamaha genos Owner's Manual page 107

3
Connect a microphone to the [MIC INPUT] jack.
For dynamic microphone connection, use the XLR connector or a standard 1/4"
phone plug connector. For a condenser microphone, use the XLR connector.
4
When using a condenser microphone, turn the [+48V] switch
on.
5
Return the [MASTER VOLUME] dial to the original level.
Adjusting the input level of the microphone
1
If necessary, turn on the microphone.
2
Call up the Mic Setting display via [MENU]  [Mic Setting].
Input level meter
3
Adjust the [MIC GAIN] knob while singing into the microphone.
Adjust the [MIC GAIN] knob so that the input level meter on the display lights in
green or yellow. Make sure that the meter does not light in orange or red, since this
indicates that the input level is too high.
4
Adjust the volume balance between the microphone sound and
the instrument sound on the Mixer display (page 86).
The combo jack accepts
either XLR or 1/4" phone
plug connectors.
NOTICE
• Do not connect or disconnect
any cables while turning on the
[+48V] switch. Doing so can
damage the connected device
and/or the instrument itself.
• When using the devices not
requiring phantom power such
as a dynamic microphone,
make sure to set the [+48V]
switch to OFF.
NOTE
When the [+48V] switch is turned on
and off, the input from the [MIC IN] jack
will be muted for a few seconds.
NOTE
You can also check the input level on
the SIGNAL lamp on the panel. Make
sure that the lamp does not light in red.
Genos Owner's Manual
107