Note
Overview
You can install a 10Base-FL Module into any of the Switch 2000's six module
slots. The following steps provide an overview. The actual installation
procedure begins on page 2.
1.
Determine whether your Switch 2000 is running the necessary operating
system (OS) version and, if necessary, download a new version (page 2).
2.
Install the 10Base-FL Module in a Switch 2000 slot (page 6).
3.
Customize the configuration for the module's ports (unless the default
port configuration is satisfactory for your network application - see page
11).
4.
Reboot the switch (page 12).
If necessary, you can "hot-swap" one 10Base-FL module for another; that is,
replace one module with another of the same type without rebooting the
switch (page 13). However, if you replace one module type with a different
module type (such as replacing a 100VG Module with a 10Base-FL Module),
you must reboot the Switch 2000 after making the replacement.
You can interchange a 10Base-T Ethernet Module and a 10Base-FL Module
without rebooting the Switch 2000.
Overview
1