Sony TRINITRON KV-34FV310 Service Manual page 120

Operating Instructions
Channels
Problem
I cannot receive
higher number
channels (UHF) when
using an antenna
Cable stations don't
seem to work
I cannot get anything
but TV
Picture in Picture (PIP)
Problem
The remote control
doesn't work in PIP
mode
There is no window
picture or it is just
static
I get the same
program in the
window picture as in
the main picture
I cannot see VIDEO
4-5 (Y, P , P ) in PIP
B R
42
Possible Remedies
❏
Make sure Cable is set to Off in the Channel menu (page 33).
❏
Perform Auto Program to add channels that are not presently in
the memory (page 23).
❏
Make sure Cable is set to On in the Channel menu (page 33).
❏
Perform Auto Program to add channels that are not presently in
the memory (page 23).
❏
Be sure that you did not set the video in the Setup menu (page 37)
to skip your video inputs. If a video input has been set to Skip, it
will be skipped when you press the TV/Video buttons for either
the main or PIP pictures.
Possible Remedies
❏
Press the TV FUNCTION button. You may have inadvertently
pressed the VCR/DVD FUNCTION button, which changes the
PIP buttons to VCR mode (page 26).
❏
Be sure your PIP window picture is set to a video source/channel
that has a program airing.
❏
You may be tuned to a video input with nothing connected to it.
Try cycling through your video inputs using the yellow PIP TV/
VIDEO button with the red dot (page 26).
❏
Both may be set to the same channel. Try changing channels in
either the main picture or the window picture (page 26).
❏
Your TV may be set up to select all your channels through a cable
box. The cable box will only unscramble one signal at a time, so
you cannot use the PIP feature. If possible, run a direct cable to the
VHF/UHF jack on your TV. This will only work if your cable
system provides an unscrambled signal (page 13).
❏
Connected equipment in VIDEO 4-5 (Y, P , P ) is not visible in PIP.
B R