D-Link DGS-3000 series Hardware Installation Manual page 46

DGS-3000 Series Gigabit Ethernet Switch Hardware Installation Guide
Feature
SFP+ Ports
PoE Ports
(DGS-3000-28LP and DGS-3000-
28XMP Only)
Description

Support Auto-negotiation for full-duplex and flow control
operations
SFP Transceivers Supported:

DEM-302S-LX (1000BASE-LX, Single-mode, 2km)

DEM-310GT (1000BASE-LX, Single-mode, 10km)

DEM-311GT (1000BASE-SX, Mutli-mode, 550m)

DEM-312GT2 (1000BASE-SX, Multi-mode, 2km)

DEM-314GT (1000BASE-LHX, Single-mode, 50km)

DEM-315GT (1000BASE-ZX, Single-mode, 80km)

DGS-712 (1000BASE-T Copper SFP, 100m)
WDM Transceivers Supported:

DEM-302S-BXD/BCU (1000BASE-BX, Single-mode, 2km)

DEM-330T/R (1000BASE-BX, Single-Mode, 10km)

DEM-331T/R (1000BASE-BX, Single-Mode, 40km)
Compliant with the following standards:

IEEE 802.3ae compliance

IEEE 802.3z compliance
SFP Transceivers Supported:

All SFP and WDM transceivers listed in the SFP Ports section
(above) will also work in the SFP+ ports.
SFP+ Transceivers Supported:

DEM-431XT-DD (10GBASE-SR, 80m: OM1 & OM2 MMF, 300m:
OM3 MMF)

DEM-431XT (10GBASE-SR (w/o DDM), 80m: OM1 & OM2 MMF,
300m: OM3 MMF)

DEM-432XT-DD (10GBASE-LR, 10km)

DEM-432XT (10GBASE-LR (w/o DDM), 10km)

DEM-433XT-DD (10GBASE-ER, 40km)

DEM-433XT (10GBASE-ER (w/o DDM), 40km)

DEM-434XT (10GBASE-ZR (w/o DDM),

DEM-436XT-BXU (10GBASE-LR BiDi (w/o DDM), 20km, TX:
1270nm, RX: 1330nm)

DEM-436XT-BXD (10GBASE-LR BiDi (w/o DDM), 20km, TX:
1330nm, RX: 1270nm )
Direct Attached Cables (DAC) with built-in transceivers:

DEM-CB100S (10G, SFP+ to SFP+, DAC, 1m)

DEM-CB300S (10G, SFP+ to SFP+, DAC, 3m)

DEM-CB700S (10G, SFP+ to SFP+, DAC, 7m)

Supports IEEE 802.3af PoE and IEEE 802.3at PoE+ compliance

Supplies power (ports 1 to 24) to PD devices up to 15.4 Watts
per port (802.3af) or 30 Watts per port (802.3at) and more
sufficiently is able to provide power to PD devices.
42