(5) Hang the end "A" of the cutter lever spring on the groove of the cutter lever, and
set the cutter lever spring to the boss of the cutter lever.
(6) Hang the "B" of the cutter lever spring on the rib of the frame cover.
(7) Insert the shaft on frame ASSY into the cutter lever and the bottom cover, and set
them to the bottom cover.
NOTE: Make sure that the positioning hole on frame ASSY fitted over the pin on
bottom cover.
(8) Secure the frame ASSY to the bottom cover with the two screws.
Cutter lever
Groove
Boss
"B"
Lubrication point
Rib
"B"
Bottom cover
Figure 3.1-19 Installing the Cutter Lever, Cutter Blind Cover and Frame ASSY
Cassette sensor harness
"A"
III - 20
Screws
Frame ASSY
Cutter lever
spring
Cutter lever