JVC MX-K30 Service Manual page 12

Removing the CD pickup (See Fig.18)
Prior to performing the following procedures,
remove the top cover and both sides board.
Also remove the CD changer unit.
Also remove the CD changer mechanism
1. Widen the section "f ".
2. While keeping the section "f" wide open, push the
section "g" in the direction of the arrow to remove
the shaft, and then remove the CD pickup.
Replacing the loading motor and rotor
blet of the CD changer (See Fig .19)
Prior to performing the following procedure,
remove the top cover.
Also open the CD changer tray.
1. Remove the two screws "L" retaining the CD
changer tray loading motor.
2. Remove the two screws "M' retaining the gear plate
and take it out, after remove the rotor belt from the
pulley.
Replacing the CD turn table and removing
the motor (See Fig. 20 and 21)
Prior to performing the following procedures,
remove the top cover.
Also remove the CD changer unit.
1. Remove the one screws "N" retaining the CD (Turn table).
2. Remove the two screws "O" retaining the stopper brackets
on both sides of the CD changer unit.
3. Remove the stopper brackets from both sides of the CD
changer unit.
4. Pull out the CD tray from the CD changer unit, all the way
and lift the tray (u/~ ward) to remove.
5. Remove the gear and after push out the tray motor locker
and pull out the tray motor from the CD tray.
Turn table motor
, and then remove the CD tray
.
Fig.21
1-12
f
Motor locker
Obligue gear
CD pickup
Shaft
Fig.18
L
Fig.19
N O
Fig.20
g
M
d