Operating Other Pioneer Components With This Unit's Sensor; Plugging In The Receiver - Pioneer VSX-C300 Operating Instructions Manual

Operating other Pioneer Components with this Unit's Sensor

By connecting a control cord to the
components using one remote sensor. Following the diagram below you will see that one component feeds the
terminal and on the other end another component is connected to the
CONTROL OUT
component that is the end point (the one that has a cord hooked up to its
whose sensor you will use. Point the remote control at that sensor when you want operate the any of the equipment
connected by this system. In the example below you would point the remote control unit towards the remote sensor
of the equipment on the left.
MEMO:
• You can also control Pioneer components by pointing the receiver's remote control directly at the component.
This type of operation does not require control cords. See page 41 for more information.
• To use this kind of remote control you have to hook up a control cord AND the have the component and
receiver hooked up with analog RCA audio/video cords as well (see page 11-13).
Point remote control towards
remote sensor of component
that only has a cord connected
to its CONTROL OUT
terminal
R L
DVD
IN
MONITOR
TV/
SAT
IN
DIGITAL
(OPTICAL)
VCR
IN
R L
AUDIO VIDEO

Plugging in the Receiver

After you have connected all your components, including the speakers, plug the receiver into a wall outlet.
SURROUND
SPEAKERS CENTER
R L
to wall outlet
MEMO:
• The power cord is removable from main unit for storage.
terminals of the respective equipment, you can control several Pioneer
CONTROL
Components
with an Î mark
ANTENNA
AM LOOP
1
FM UNBAL 75Ω
OUT
2
R L
VCR
OUT
SUB
WOOFER
AUDIO
OUT
AC IN
IN OUT
CONTROL
Connecting Your Equipment
CONTROL OUT
Mono mini plug
(optional)
FRONT SURROUND
SPEAKERS
CENTER
R L R L
Power cord CAUTION!
Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or electric
shock. Do not place the unit or a piece of furni-
ture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with
other cords. The power cords should be routed
such that they are not likely to be stepped on.
A damaged power cord can cause a fire or give
you an electrical shock. Check the power cord
once in a while. When you find it damaged,
ask your nearest PIONEER authorized service
center or your dealer for a replacement.
terminal. The
CONTROL IN
only) it is the component
Components
with an Î mark
Mono mini plug
(optional)
AC IN
IN OUT
CONTROL
17
En