Technicolor UIW8001 Installation Manual page 14

Environmental information
Energy efficiency
Energy savings - We have a role to play...
Technicolor is proud to offer you high-
standard products with a variety of eco-
friendly attributes. Next to carefully
selected plastics and packaging to
minimize our ecological footprint, our
products benefit from a unique
combination of hardware and software
features that reduce energy
consumption substantially.
The accompanying product documentation not
only provides useful information on all the
features of your product, but also on its energy
consumption. We strongly encourage you to
carefully read the product documentation before
putting your equipment in service in order to get
the best service it can offer you.
By working together, we can reduce the impact we
have on our earth!
Batteries (if applicable)
Batteries use some hazardous
substances which pollute the
environment. Do not dispose of
them with other articles. Take care to
dispose them at special collecting
points.
Recycle or dispose of batteries in
accordance with the battery
manufacturer' s instructions and
local/national disposal and recycling
regulations.
Safety instructions
• Read these instructions.
!
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
Climatic conditions
This product:
• Is intended for in-house stationary use; the
maximum ambient temperature must not
exceed 40 °C (104 °F); the relative humidity
must be between 20 and 80 %.
• Must not be mounted in a location exposed to
direct or excessive solar and/or heat radiation.
• Must not be exposed to heat trap conditions
and must not be subjected to water or
condensation.
• Must be installed in a Pollution Degree 2
environment (an environment where there is no
pollution or only dry, non-conductive pollution).
If applicable, batteries (battery pack or batteries
installed) must not be exposed to excessive heat
such as sunshine, fire or the like.
Ventilation and positioning
This equipment is intended to be used indoor in a
residential or office environment.
• Remove all packaging material before applying
power to the product.
• Place and use the product only in positions as
described in the accompanying product
documentation.
• Do not block or cover any ventilation openings;
never stand it on soft furnishings or carpets.
• Never push objects through the openings in
this product.
• Leave 7 to 10 cm (3 to 4 inches) around the
product to ensure that proper ventilation gets
to it.
• Do not install the product near any heat sources
such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
• Do not put anything on it which might spill or
drip into it (for example, lighted candles or
containers of liquids). Do not expose it to
dripping or splashing, rain or moisture. If a liquid
enters inside the product, or if the product has
been exposed to rain or moisture, unplug it
immediately and contact the Customer
Service.
Cleaning
Unplug this product from the wall socket and
disconnect from all other devices before cleaning.
Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning.
Water and moisture
Do not use this product near water, for example
near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement or near a swimming pool.
Transition of the product from a cold environment
to a hot one may cause condensation on some of
its internal parts. Allow it to dry by itself before re-
starting the product.
Electrical powering
The powering of the product must adhere to the
power specifications indicated on the marking
labels.
In case this product is powered by a power supply
unit:
• This power supply unit must be Class II and a
Limited Power Source in accordance with the
requirements of IEC 60950-1/EN 60950-1,