Honda Civic 2002 Service Manual page 6

5. Pull out the switch panel (A)to release the hook (B),
then remove the panel from the door panel.
Disconnect the power window switch connector (C).
Release the clips that hold the door panel (A) with a
commercially available trim pad remover (B), then
remove the door panel by pulling it upward.
Remove the door panel with as little bending as
possible to avoid creasing or breaking it,
Fastener Locations
95 mm (3.74 in.l
12 mm
r q----------
i.0.17 in.l r <_--'r-
> : Clip,9
ffi
EtA
l m m
{0.04 in.l
45 mm {1.77 in.l
7. Disconnect the inner handle cable {A) from the
i n n e r h a n d l e ( B ) , a n d d i s c o n n e c t t h e p o w e r d o o r
lock switch connector (C) {driver's). Take care not to
bend the cable.
8. Detach the harness clip (A)from the door panel (B).
B
Install the door panel in the reverse order of
removal, and note these items:
. Replace any damaged clips.
. Make sure the cable is connected securely, and
the connector is plugged in properly.
. Check the window and power door lock
operatrons,
9 .
20-5