Section 4 : Other Speaker Features; Reset To Factory Setting - Creative ZiiSound D5x Quick Start Manual

Section 4 : Other speaker features

4.1
Returning to standby and Powering On the D5x with active Links
A Returning to Standby
The Linked speakers can be brought to Standby in unison by pressing the Power ON/Standby
Button located at the rear of the RIGHT Master speaker.
Powering ON with active links
B
The Linked speaker can be Powered ON with active links to each other by pressing the Power
ON/Standby Button of the RIGHT Master speaker with the mains powered ON on all the other
speakers.*
*Powering ON with active links can only be done on the Master speaker as the slave speakers are listening to instructions
from the Master speaker, even in standby.
4.2
Disabling / Restoring the link system for individual / Linked
speaker usage
Disabling the LINK for individual D5x operation
A
You can disable the LINK connection to all the linked speakers by simply pressing the LINK
Touchpad / Button once on the RIGHT Master speaker. This will bring down the LINK and restore
the functions of the Volume control, AUX-IN, CONNECT Touchpad and Volume Touchpad / Button,
which locked in link mode, back to each individual D5x. Once activated, there is no LED indication
on the LINK LED status indicator for all D5x.
ZiiSound D5x
CENTER Speaker
ZiiSound D5x
LEFT Speaker
0
(only for 2.0 and above setup)
ZiiSound D5x
RIGHT Speaker
Restoring LINK for linked speaker usage
B
To restore the LINK from the sets of individual speakers, you can Press the LINK Touchpad / But-
ton once on either any of the speakers with all other D5x(s) and subwoofer Powered ON**. This
will result in restoring the state of the speakers shown by it LED indication in either Multi-channel
or Party mode.
** For the ZiiSound D5x, Powered ON is indicated with the Volume LED Status Indicator lit up.
4.3

Reset to factory setting

Follow these steps to return to factory settings to clear Bluetooth paired device memory and Link
configurations in the ZiiSound D5x.
Action
Transmitter
Disconnect the Transmitter
Press and hold the Pairing Button while
inserting the Transmitter to iPhone/iPod and
hold for 8 seconds
ZiiSound D5x
Return the speaker to Standby by pressing the
Power ON/ Standby button.
Press and hold Power button for 10 seconds.
Note: The above can also be applied to LEFT and CENTER speaker to clear Bluetooth paired device memory and Link configurations
should the need arise.
LED status Status
Transmitter LED Transmitter has been reset
fast blinks and is in pairing mode
CONNECT LED and LINK Powered On. Ready for next
LED blinks twice and user action.
turns off. This indicates a
successful Factory reset.