Hitachi LP-WU6600 User Manual page 23

18. Auto / 0
This button is used to Resync the picture;
when the picture signal becomes unstable
or picture quality deteriorates simply
press this button and the projector will
automatically adjust the screen dimension,
phase, timing and so forth.
Number for Remote ID setting used.
19. Brightness
Displays the brightness setting bar.
20. Contrast / 2
Displays the Contrast settings bar.
Number for Remote ID setting used.
21. Light
Displays the light source selections.
22. Zoom / 4
Displays the digital zoom settings bar.
Number for Remote ID setting used.
23. Freeze
Freezes/unfreezes the on-screen picture.
24. Blank / 6
Makes the screen blank.
Number for Remote ID setting used.
25. STANDBY
This button is used to turn off the
projector.
26. Video / S-Video
Displays the Video source selection.
27. Network
Open the OSD Network menu.
28. EXIT
Press this button to exit, hide the OSD
menu or return to previous OSD menu
level.
29. ► /
Use this button to make your selection or
configure, adjust configuration.
Hotkeys for 2D keystone adjustment menu.
30. MHL
Displays the MHL source selection.
31.
Forward in set increments for MHL.
32.
Play the following item on the
programming list for MHL.
33. Volume / 1
Displays the Volume setting bar.
Number for Remote ID setting used.
34. Mute /3
Mutes the built-in speaker.
Number for Remote ID setting used.
35. 3D / 5
Open the OSD 3D Setting menu.
Number for Remote ID setting used.
36. Status / 7
Opens the OSD Status menu (the menu
only opens when an input device is
detected).
Number for Remote ID setting used.
37. Wire jack
Connect wire remote to the projector.
Note:
Remote Combo Key Settings:
ID+0: Reset Remote Control
customer code to default settings.
ID+1: Set Remote Control customer
code to "1".
~
ID+7: Set Remote Control customer
code to "7".
Projector also need setting ID for
unique control. Refer to " Page 66
: Remote ID ".
Note: When the projector is under MHL
mode, The keypad on projector
should be with the same definition of
the key on remote control.
When MHL function:
MENU for App settings, ▲ Up, ▼
Down, ◄ Left and ► Right are used
as directional arrows, also included
ENTER and EXIT.
Controlling your smart device with
the remote control:
When the projector projects the
contents from your MHL compatible
smart device, you can use the remote
control to control your smart device.
To enter the MHL mode, the
following buttons are available for
controlling your smart device, Arrow
keys (▲ Up, ▼ Down, ◄ Left, ►
Right), MENU, EXIT, MHL control
buttons.
Remote control
23