Learning Remote Control Function - Pioneer PDP-4330HD Operating Instructions Manual

Useful features

Learning remote control function

You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD) using the
learning function for your remote control unit. This remote control unit has a function that can memorize each
remote control code.
TV
TV
ANT
FRONT
AV SURR
SELECTION
SPLIT
SCREEN
MODE FREEZE
DISPLAY SLEEP
1
4
7
CH
MENU
RETURN
SOURCE
A
INPUT
PLASMA DISPLAY
2 to 5 cm (0.8 to 2.0 inch)
Remote control
(Supplied accessory)
CBL VCR DVD
/SAT /LD
/DTV
INPUT
MTS CC
SELECT
SUB SUB CH
INPUT
EDIT/ LEARN
2 3
5 6
8 9
CH
0
ENTER
CH
RETURN
VOL
MUTING
TV/SAT/DVD DTV/DVD TOP
MENU MENU
DTV/SAT
GUIDE
SET/
ENTER
DTV/SAT
INFO
VCR REC
FAVORITE CH
B C D
VOL VOL
RECEIVER
Remote control of
AV product
Presetting manufacture codes
1
Slide the Mode switch to match the device to which
you want to preset the remote control signal.
2
Press EDIT/LEARN and 1 at the same time.
• LED flashes continuously.
3
Press 0 – 9 to enter the manufacture code. (See
page 57.)
• Preset mode is finished once the LED no longer lights
up.
A
• To stop the EDIT mode in the middle, press EDIT/LEARN
once more.
• If Mode switch is switched while in EDIT mode, EDIT mode
will be canceled.
• If there is no operation for over 1 minute running, exit this
mode.
• When you enter a code that is not listed, LED flashes
quickly.
• If the table on page 57 does not include your desired
manufacturer or the remote control does not work, you
can make the memory learn its signal by the learn mode.
• The initial mode is "00" (PIONEER).
Learning the remote control
1
Be sure to slide the Mode switch to match the
device whose remote control signal you want to be
learned.
2
Press EDIT/LEARN and 2 at the same time.
• LED flashes continuously.
3
Press a button for you want to learn.
• Refer to the assigning buttons to functions on each
page.(See page 58 to 63.)
• The LED changes from lit up to flashing state.
• When the learn mode is finished, LED lights up once
and returns to the learn mode (LED flashes
continuously).
4
To exit learn mode, press EDIT/LEARN.
A
• To stop the EDIT mode in the middle, press EDIT/LEARN
once more.
• If Mode switch is switched while in EDIT mode, EDIT mode
will be canceled.
• If there is no operation for over 1 minute running, exit this
mode.
• If TV a is pressed over 2 seconds running (LED flashes
continuously, step 2 above), the learning codes of the
current Mode switch position clear, changing back to
preset manufacturer codes. In this case, the LED turns
off after 2 seconds exiting learning mode.
E-56