Connect The Speaker Cables - Pioneer Elite KURO PRO 111FD Operating Instructions Manual

Install Your Flat Panel TV
02
8 ) Insert the cable in the groove on the speaker.
Speaker cable
9 ) Connect the other end of the speaker cables to the rear of the panel.
Refer to "
Note: If the speaker needs to be repositioned (horizontally or vertically) after it is attached, loosen the speaker
mounting screws first. Adjust the position then retighten the screws.

2.2.2 Connect the Speaker Cables

1 ) Press down on the tab.
2 ) Insert the appropriately colored wire into the opening.
3 ) Allow a small percentage of the cable's bare wire to remain visible.
4 ) Release the tab to clamp the wire.
If the bare wire is hidden when the tab is released, repeat Steps 1
through 4 until the proper amount of cable is showing.
5 ) Repeat this process for each cable, matching the color of the wire to the
appropriate terminal.
6 ) Connect the speaker cables to the speaker.
7 ) Bundle the speaker cables, power cord and other cables in the cable
clamp then insert the clamp into an appropriate hole on the rear of the
flat panel TV.
Refer to "2.7 Route then Bundle the Power Cord and Cables."
Use the clamps as necessary (see page 33).
22
En
(PRO-151FD)
Speaker
terminal
Insertion
in groove
2.2.2 Connect the Speaker Cables."
Speaker terminal
(PRO-111FD)
Speaker cable
Speaker terminal
tab
Black
Gray
Gray
Red
Red
Black
(PRO-151FD)
Speaker cable
Insertion
in groove