What's In The Box; Putting The Batteries In The Remote; Control; Using The Remote Control - Pioneer DV-989AVi-S Operating Instructions Manual

01 Before you start

What's in the box

Please confirm that the following accessories
are in the box when you open it.
• Remote control
• AA/R6P batteries x2
• Stereo audio cable (red/white plugs)
• Video cable (yellow plugs)
• 4-pin S400 i.LINK cable
• Power cable
• These operating instructions
Putting the batteries in the
remote control
1 Open the battery compartment cover
on the back of the remote control.
2 Insert two AA/R6P batteries into the
battery compartment following the indi-
cations ( ,
3 Close the cover.
8
En
) inside the compartment.
Incorrect use of batteries can result in
hazards such as leakage and bursting.
Please observe the following:
• Don't mix new and old batteries together.
• Don't use different kinds of battery
together—although they may look similar,
different batteries may have different volt-
ages.
• Make sure that the plus and minus ends
of each battery match the indications in
the battery compartment.
• Remove batteries from equipment that
isn't going to be used for a month or
more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction's rules
that apply in your country or area.

Using the remote control

Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote
sensor on the unit.
• The remote has a range of about 7 meters.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located
close to this unit.
• Replace the batteries when you notice a
fall off in the operating range of the
remote.
H048 En