Clear Added Manufacturer Codes From The Remote Control; Control A Pioneer Receiver - Pioneer Kuro Elite PRO-101FD Operating Instructions Manual

Use Other Equipment With Your Flat Panel Display
06
6.1.4

Clear Added Manufacturer Codes from the Remote Control

To return all learned and preset codes to the defaults (PIONEER), follow the steps below.
1 ) Simultaneously press EDIT and MONITOR () buttons to begin.
Selection can be in any mode.
2 ) Press the Yellow button to clear added codes.
Confirm that the selected mode indicator flashes.
The remote control enters the Manufacturing Reset mode. The
reset is complete when the mode indicator flashes once. The
remote control then returns to normal operation.
Note: The panel's remote control may not control or have complete
control of some equipment listed in the tables.
To exit before the reset is complete, press the EDIT button again. The reset is cancelled if no action is taken within
60 seconds. Switching the Mode during this procedure also cancels the reset.
6.1.5

Control a Pioneer Receiver

The flat panel display's remote control has a bank of buttons specifically for controlling a Pioneer receiver. The
active buttons, left to right, are as follows:
• RECEIVER STANDBY/ON
(turns the Pioneer Receiver On/Off)
• RECEIVER INPUT
(cycles through/selects an input)
• RECEIVER VOL –
(adjusts the volume lower)
• RECEIVER VOL +
(adjusts the volume higher)
48
En
MONITOR
INPUT
1 2 3 4
MENU
ON D EMAND FAVORITE
DVD/HDD
SOURCE
RECEIVER
VOL
INPUT
SELECT BDP EDIT/LEARN
MONITOR STB LD VCR
CBL DVD
SAT DVR
DVD/HDD
SOURCE
RECEIVER
VOL
INPUT
SELECT BDP EDIT/LEARN
MONITOR STB LD VCR
CBL DVD
SAT DVR