Echo PB-760LN Operator's Manual page 25

Check spark plug
a: 0.6 - 0.7 mm
Throttle cable adjustment
1. Handle
3. Adjustment screw
1. Throttle trigger
2. Locking knob
a. 4-6 mm
Maintenance and care
Tools required: T-Wrench, Feeler gauge
Parts required: Spark plug
IMPORTANT
Use only NGK BPMR6Y spark plug otherwise severe engine
damage may occur.
1. Check plug gap. Correct gap is 0.6 mm to 0.7 mm.
2. Inspect electrode for wear.
3. Inspect insulator for oil or other deposits.
4. Replace plug if needed and tighten to 15 N·m - 17 N·m (150
kgf·cm to 170 kgf·cm).
Tools required: Torx L-Wrench T27
Parts required: None
If engine idle speed changes when blower pipe is moved, or en-
gine will not reach full wide open throttle speed, adjust throttle ca-
ble.
1. Loosen handle adjustment Locking knob and tilt Tube Throt-
tle handle forward to expose Adjustment screw .
2. Turn Adjustment screw until Throttle Trigger free play is 4 -
6 mm.
3. After adjustment, squeeze and release Throttle trigger sev-
eral times to verify Carburettor Throttle shaft has full range
of movement from idle to wide open throttle positions.
25