Pioneer Premier DEH-P700BT Operation Manual page 30

Section
02 Operating this unit
5 Select PAIRE FROM PHONE and then
press MULTI-CONTROL to ready for pairing.
READY will be displayed.
6 Use your cellular phone to establish
connection.
PIN code is set to 0000 as the default. You can
change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection on page 48.
While connecting, CONNECTING is displayed.
If the connection is established, COMPLETED
is displayed.
After connected, this unit automatically
changes to PH. BOOK DL (phone book down-
load confirmation) display.
# If the connection fails, ERROR is displayed. In
this case, check the cellular phone and try again.
# If three cellular phones have already been
paired, the pairing assignment selection display
will appear. Select one assignment to pair the
new phone. The newly paired phone overwrites
the previously paired phone. The assignment se-
lection operation is the same as Step 3 to 4 of
Pairing a connected cellular phone on the next
page except for the operation below.
! Switching the BD address and device name
7 Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push MULTI-CONTROL left or right to select
NO (No) or YES (Yes).
Press MULTI-CONTROL to decide.
When you select YES, this unit changes to
PH BOOK DOWNLOAD and the download op-
eration automatically begins. After complet-
ing, DATA DOWNLOADED is displayed.
According to the circumstances, this unit
changes to PH BOOK TRANSFER. In this case,
refer to step 4 on Transferring entries to the
phone book on page 39.
# When you select NO, the display reverts to
normal.
30
En
Using this unit to initiate a connection
1 Display the connection menu.
Refer to Introduction of connection and regis-
tration on the previous page.
2 Use MULTI-CONTROL to select
BT HANDS FREE.
3 Use MULTI-CONTROL to select a group.
Push MULTI-CONTROL up or down to select a
group.
NOKIA (Nokia)—STANDARD (standard)
# Normally select STANDARD. If the device of
Nokia is not paired to this unit, select NOKIA.
# Push MULTI-CONTROL left or right to display
a group name or an ID.
4 Press MULTI-CONTROL to switch to
PAIRE FROM PHONE.
Push MULTI-CONTROL up or down to switch
PAIRE FROM PHONE and SEARCH DEVICE.
5 Select SEARCH DEVICE and then press
MULTI-CONTROL to start searching.
While searching, SEARCHING is displayed.
# If this unit fails to find any available cellular
phones, NOT FOUND is displayed.
6 Use MULTI-CONTROL to select a device.
Push MULTI-CONTROL up or down to select a
device name you want to connect.
Press MULTI-CONTROL to select a device
name.
# Push MULTI-CONTROL left or right to switch
the BD address and device name.
7 Use your cellular phone to establish
connection.
PIN code is set to 0000 as the default. You can
change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection on page 48.
While connecting, CONNECTING is displayed.
If the connection is established, COMPLETED
is displayed.
After connected, this unit automatically
changes to PH. BOOK DL (phone book down-
load confirmation) display.