Preparation; Atiaching The Stand; Preparing Your Lcd 1V For Wall Mounting; Turning On The Lv - Haier 39G2000 User Manual

PREPARATION
IMPORTANT: Do not apply pressure to the screen display
area which may compromise the integrity of the display.
The manufacturer's warranty does not cover user abuse
or improper installations.
ATTACHING THE STAND
IMPORTANT: The stand of the TV must be assembled
prior to usage.
1. Place TV unit face down on a soft and flat surface
(blanket, foam, cloth, etc.) to prevent any damage to
the TV.
2. Fix the stand to the bottom of the TV with
the four B4x16F mm screws.
~.,
"'
B4x16mm
(4pcs)
PREPARING YOUR LCD TV FOR WALL MOUNTING
We suggest that you keep your TV at least 2.36 inches
(60 mm) from the wall to prevent cable interference.
Before mounting your TV on the wall, you need to
remove the stand.
For your safety, please use only with a
UL
listed wall
mount bracket with minimum weight of the
1V
without
stand. (Please see page 1 8 for the weight of the TV.)
To attach a wall mount bracket to your TV:
1. Remove the screws holding your TV to the stand.
2. Remove the stand from your TV.
3. Secure the wall mount bracket to the back of your
1V
using four screws (see page 18 for the size of the
screws). Follow the instructions of the user manual
that came with the wall mount bracket to install.
~
/
• •
.
-
I
D
.
c::::::J i
. .
"'
~ ~
NOTE
The wall mount bracket and the screws are not
Included.
7
TURNING ON THE TV
1. Install the stand and place the TV on a solid surface.
itll·U·
• Ensure that the TV is placed in a position to allow free
flow of air. Do not cover the ventilation openings on the
back cover.
• To prevent any unsafe situations, no naked flame sources,
such as lighted candles, should be placed on or in the
vicinity.
• Avoid heat, direct sunlight and exposure to rain or water.
The equipment shall not be exposed to dripping or
splashing.
2. Connect the antenna cable or cable TV cable to the
ANT IN
aerial socket on the back of the TV set. See
"CONNECTING TO AN ANTENNA/CABLE WALL JACK''
on page9.
3.
Remote control:
Remove the cover ofthe battery compartment.
Insert the 2 supplied batteries (Type AAA 1.SV).
4. Power:
Plug the cord into a working power outlet.
~ -!'
.. .. ....
, " "
""
~~
0
.
.
.
41f!Jl
~
~
A I'
5.
Turn the
1V
on:
Press C) on the remote control or
POWER
button on
the side control panel of the TV.