Xconfiguration Network [1] Qos Diffserv Ntp; Xconfiguration Network [1] Remoteaccess Allow; Xconfiguration Network [1] Vlan Voice Mode; Xconfiguration Network [1] Vlan Voice Vlanid - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

xConfiguration Network [1] QoS Diffserv NTP

This setting will only take effect if Network QoS Mode is set to Diffserv.
Define which priority NTP packets should have in the IP network.
The priority for the packets ranges from 0 to 63 - the higher the number, the higher the priority.
The recommended value for NTP is 0, which means best effort. If in doubt, contact your
network administrator.
The priority set here might be overridden when packets are leaving the network controlled by
the local network administrator.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Network QoS Diffserv NTP:
n
where
n
: Index that identifies the network. Range: 1..1
NTP
: Integer (0..63)
Set the priority of the NTP packets in the IP network - the higher the number, the higher
the priority. The default value is 0 (best effort).

xConfiguration Network [1] RemoteAccess Allow

Define which IP addresses (IPv4/IPv6) are allowed for remote access to the codec from SSH/
Telnet/HTTP/HTTPS. Multiple IP addresses are separated by a white space.
A network mask (IP range) is specified by <ip address>/N, where N is 1-32 for IPv4, and N is
1-128 for IPv6. The /N is a common indication of a network mask where the first N bits are set.
Thus 192.168.0.0/24 would match any address starting with 192.168.0, since these are the first
24 bits in the address.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration Network RemoteAccess Allow: "Allow"
n
where
n
: Index that identifies the network. Range: 1..1
Allow
: String (0, 255)
A valid IPv4 address or IPv6 address.
Cisco TelePresence SX10 API Reference Guide CE8.2, SEPTEMBER 2016.
D15333.07
About the API xConfiguration xConfiguration
NTP
xCommand

xConfiguration Network [1] VLAN Voice Mode

Define the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you
have Cisco UCM (Cisco Unified Communications Manager) as provisioning infrastructure. Note
that Auto mode will NOT work if the NetworkServices CDP Mode setting is Off.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Network n VLAN Voice Mode:
where
n
: Index that identifies the network. Range: 1..1
Mode
: Auto/Manual/Off
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN.
If CDP is not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If
CDP is available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.

xConfiguration Network [1] VLAN Voice VlanId

Define the VLAN voice ID. This setting will only take effect if Network VLAN Voice Mode is set
to Manual.
Requires user role: ADMIN
Default value: 1
USAGE:
xConfiguration Network VLAN Voice VlanId:
n
where
n
: Index that identifies the network. Range: 1..1
VlanId
: Integer (1..4094)
Set the VLAN voice ID.
67
API Reference Guide
xStatus Appendices
Mode
VlanId
Copyright © 2016 Cisco Systems, Inc. All rights reserved.