Advertisement
Quick Links
DX-200 Series
Digital Dispenser/Controller
FEATURES
3
2
1
8
Front View
CONNECTING THE UNIT
1
2
Installing the Bracket and Air Hose Holder:
1. Align the bracket over the power and Foot
switch cord
2. Place the Air Hose Holder in the center of
bracket
3. Tighten the two mounting screws
12151 Monarch Street, Garden Grove, CA 92841
QUICK START UP GUIDE
4
10
9
5
15
14
6
7
Back View
3
A
B
DX-300
•
+1 714 799-9910
11
12
13
Items
Description
1
To Air Source
2
Air Filter (Not Included)
3
Power Adapter
4
Foot Switch
4
•
•
+1 714 799-9533 fax
Items
Description
1
Power Button
2
Mode Button
3
Set up/Save Button
4
Display
5
Air Pressure Gauge
6
Air Pressure Regulator
7
Pulsed Air Outlet
8
Vacuum Control
9
Foot Switch Receptacle
10
Power Receptacle
11
I/O Connection
12
Exhaust Port
13
Constant Air Outlet
14
Air Inlet
15
Cord Lock
Air Hose
Holder
Bracket
Power and
Foot Swit
Cord
www.okinternational.com
ch
Advertisement
Summary of Contents for Oki DX-200 Series
- Page 1 DX-200 Series Digital Dispenser/Controller QUICK START UP GUIDE FEATURES Items Description Power Button Mode Button Set up/Save Button Display Air Pressure Gauge Air Pressure Regulator Pulsed Air Outlet Vacuum Control Foot Switch Receptacle Power Receptacle I/O Connection Exhaust Port Constant Air Outlet...
- Page 2 HOW TO SET-UP PURGE DISPENSE CYCLE 1. Press Power Button to turn on unit 2. Press Mode Button to select “PURGE” Mode 3. Rotate Air Pressure Regulator knob clockwise 4. Attach Receiver Head Assembly to syringe (CW) until desired pressure is indicated on the pressure gauge Pressure Gauge...
- Page 3 HOW TO SET-UP DISPENSE TIME 2. Press and hold Set Button for two seconds to enter 1. Push Mode Button to select “CONTINUE” or “SETUP” mode. “INTERRUPT” Mode (The last digit is highlighted with a blinking cursor) 4. Press (+) or (-) Activation Button to set 3.
- Page 4 HOW TO RESET CYCLE COUNTER . Press and hold Set Button for 4 1. Press Set Button to enter “SETUP” mode seconds to reset counter Counter OPERATION DIAGRAM MODE :Press then release :Press and hold for approximately 2 seconds then release Prog Time Counter :Press and hold for approximately 4 seconds then release...