Camera Commands; Xcommand Camera Positionreset; Xcommand Camera Preset Activate; Xcommand Camera Preset Activatedefaultposition - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

Camera commands

xCommand Camera PositionReset

Reset the camera position to default position.
Requires user role: USER
USAGE:
xCommand Camera PositionReset [Axis: Axis] CameraId:
where
Axis: All/Focus/PanTilt/Zoom
Select which motor to reset. If not specified all are reset.
CameraId: Integer (1..7)
The ID of the camera preset you want to reset.

xCommand Camera Preset Activate

Activate one of the stored camera presets.
Note that the xCommand Camera Preset commands applies to an individual camera. This is
in contrast to the xCommand Preset commands where a single preset covers ALL connected
cameras plus the Video Input switcher settings.
Requires user role: USER
USAGE:
xCommand Camera Preset Activate PresetId:
where
PresetId: Integer (1..35)
The ID of the camera preset you want to activate.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration
CameraId
PresetId
xCommand xCommand

xCommand Camera Preset ActivateDefaultPosition

Sets the cameras to their default position, if one is defined. The default position is defined
by xCommand Camera Preset Store or by xCommand Camera Preset Edit. Only one default
position can be defined per camera.
Requires user role: USER
USAGE:
xCommand Camera Preset ActivateDefaultPosition [CameraId: CameraId]
where
CameraId: Integer (1..7)
The ID of the camera preset you want to activate. If CameraId is not specified, all
cameras will be set in their respective default position, if one is defined.
100
API Reference Guide
xStatus Appendices
Copyright © 2016 Cisco Systems, Inc. All rights reserved.