Aiwa CSD-FD79 Service Manual page 31

ELECTRICAL ADJUSTMENT - 3/5
QQ
3 7 63 1515 0
<FM Adjustment>
Make the following preparation for FM adjustment.
Preparation
• Measuring instruments: Standard Signal Generator (S.S.G) /Oscilloscope/Millivoltmeter
1) Connect the unit and measuring instruments as shown in the diagram below.
2) Position the loop antenna connected to S.S.G. and the one connected to the unit 60cm apart.
Standerd Signal Genertaor
5. FM Tracking Adjustment
Requirement:
• Test point: HP OUT
• Adjustment location: L002
1) Set S.S.G. to FM, carrier 87.5MHz with 75KHz modulation, source at 1KHz.
2) Tune the unit to the receiving frequency at FM 87.5KHz.
3) While monitoring the waveform at 1KHz through the oscilloscope, lower the output level of S.S.G. maximum
(till a certain degree or noise is monitored).
4) Adjust L002 so that the millivoltmeter indicates maximum.
TE
L 13942296513
www
.
http://www.xiaoyu163.com
SET
FM ANT
HP OUT(L)
HP OUT(R)
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
AC MILLIVOLTMETER
CH1 CH2
CH1
Q Q
3 6 7 1 3 1 5
co
.
-31-
9 4 2 8
OSCILLOSCOPE
OUTPUT
CH2
0 5 8 2 9 9 4 2 8
m
9 9
9 9