Before Using Your Vcr 5 - Philips VRA641AT Owner's Manual

Removing the Plastic Cover from the Front Panel
A thin, plastic cover may protect the front panel of your VCR.
Before using the VCR, lift a corner of the plastic, then peel it off.
Putting Batteries in the Remote Control
1
To remove the battery compartment lid, push in the tab,
then pull up the lid.
2
Place two AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
3
Replace the battery compartment lid.
Using the Remote Control
•
Do not put objects between the remote control and the VCR.
•
Point the remote control at the VCR's remote sensor, then press
the VCR button before pressing other VCR operation buttons.
•
Point the remote control at the TV, then press the TV button
before pressing other TV operation buttons.
•
Point the remote control at the Cable Box/DBS, then press the
CBL/DBS button before pressing other Cable Box/DBS operation
buttons.
Erase Protection
Video cassettes have record tabs to ensure that recordings are
not erased accidentally.
1
To prevent accidental erasure, break off the tab with a
screwdriver.
2
To record again, cover the hole with cellophane tape.
VCR Maintenance
•
Remove any light adhesive stick-on notes from the video cassette
before putting the cassette in the VCR. Removable labels can jam
the VCR.
•
Periodic maintenance is required to maintain your VCR's
performance. Your VCR has an automatic head cleaner, but the
video heads eventually will require cleaning or replacement. Only
an authorized service center should perform this service.

Before Using Your VCR 5

1
2
3
1
2
Helpful Hints
• The remote control and its batteries
are supplied.
• Do not mix alkaline and manganese
batteries.
• Do not mix old and new batteries.