Connecting Without A Scart Cable; Connecting A Decoder Or Other Equipment - Philips VR200/58 Operating Instructions Manual

Connecting without a scart cable

a
Switch off the TV set.
b
Remove the aerial cable plug from your TV set and insert
it into the socket at the back of the video recorder.
2
c
Plug one end of the aerial cable provided into the
socket on the video recorder and the other end into the
aerial input socket on your TV set.
d
Insert one end of the mains cable into the mains socket
at the back of the video recorder and plug the other
4
end into the wall socket.
e
Switch on your TV set and select the programme number
that you have chosen for video playback (see instruction
manual TV set).
f
Tune in the TV set in the UHF wave band until the
following picture appears.
D The video recorder will now send on channel
CH36/frequency 591MHz:
CONGRATULATIONS ON THE
PURCHASE OF YOUR NEW
PHILIPS VIDEO RECORDER
TO CONTINUE PRESS OK
g
Then read 'Initial installation' in the chapter 'INSTALLING
YOUR VIDEO RECORDER'.

Connecting a decoder or other equipment

You can connect additional equipment to the
socket. For example: a decoder, a satellite receiver or a
camera recorder.
3
EXT.2 AV 2
5