Cisco Catalyst Blade Switch 3020 Installation Manual page 14

Running Express Setup
The Express Setup page appears. (See
Figure 2-9
Step 9 Go to
using the Express Setup screen of the Device Manager.
Completing the Express Setup Fields
Follow these steps to finish setting up the switch module:
Enter this information in the Network Settings fields:
Step 1
(Optional) You can enter the Optional Settings information now or enter it later by using the device
Step 2
manager interface:
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
2-14
Express Setup Page
"Completing the Express Setup Fields" section on page 2-14
In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only
–
if you want to change the management interface through which you manage the switch module
and to which you assign IP information. The VLAN ID range is 1 to 1001.
In the IP Address field, enter the IP address of the switch module. In the IP Subnet Mask field,
–
click the drop-down arrow, and select an IP Subnet Mask.
– In the Default Gateway field, enter the IP address for the default gateway (router).
Enter your password in the Switch Password field. The password can be from 1 to 25
–
alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,
but does not allow spaces at the beginning or end. In the Confirm Switch Password field, enter
your password again.
In the Host Name field, enter a name for the switch module. The host name is limited to
–
31 characters; embedded spaces are not allowed.
In the System Contact field, enter the name of the person who is responsible for the switch
–
module. In the System Location field, enter the wiring closet, floor, or building where the
switch module is located.
In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch
–
module by using the CLI. If you enable Telnet access, you must enter a Telnet password.
Figure 2-9.)
Chapter 2 Switch Installation
to finish setting up the switch module
OL-8914-02