50" Inch Blower System
1.
Remove mower deck from chassis. Refer to Opera-
tor's Manual if necessary. Pull out defl ector pin and
remove defl ector chute. Remove existing chute
hinge support, retaining hardware for reuse.
2.
Attach blower mount bracket to deck with existing
hardware and tighten to 70-80 ft./lbs.
3.
Remove right pulley guard.
4.
From under the mower deck, remove shaft from
right blade spindle.
WARNING!
Blades are sharp. Protect your hands
with gloves and/or wrap blades with a
heavy cloth when handling.
5.
Install new shaft. Use existing deck pulley. Install
spacer and key from kit, as shown in illustration.
Install pulley and secure with original fl at washer
and 1½ bolt from kit. Orient the raised portion of
pulley hub to the bottom.
6.
Install idler pulley using 1¾ bolt, placing spacer
under pulley. Secure with nyloc nut.
7.
Individual preference for either HiLift or LoLift
blades may vary, depending on mowing conditions
and type and heaviness of grass to be bagged.
Tighten blade, attaching hardware to 60-70 ft./lbs.
INSTALLATION INSTRUCTIONS
44"/50" RAM BLOWER
P/N 44" 539 130360 / 50" 539 130372
Defl ector Chute
Blower Mount
Bracket
Chute Hinge
Support - remove and replace
Spacer
50" Deck
Pulley Guard
Defl ector Pin
Shaft
1¾ Bolt
Idler Pulley
1½ Bolt
Pulley
(hub down)
Shaft
8059-019
Spacer
Key
8059-020