DeWalt DW505 Instruction Manual
1/2" (13 mm) dual speed range hammerdrill
Hide thumbs
Also See for DW505:
- Instruction manual (25 pages) ,
- Manual (84 pages) ,
- Instruction manual (25 pages)
Related Manuals for DeWalt DW505
Summary of Contents for DeWalt DW505
- Page 1 Instruction Manual DW505 1/2" (13 mm) Dual Speed Range Hammerdrill Questions? See us on the World Wide Web at www.D WALT.com final page size: 8.5 x 5.5 in...
- Page 2 English (original instructions)
- Page 3 English Definitions: Safety Alert Symbols and Words This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
-
Page 4: General Power Tool Safety Warnings
English GENERAL POWER TOOL SAFETY WARNINGS b ) Use personal protective equipment. Always wear eye protection. Protective equipment such as dust WARNING! Read all safety warnings and all mask, non-skid safety shoes, hard hat, or hearing instructions. Failure to follow the warnings and protection used for appropriate conditions will reduce instructions may result in electric shock, fire and/or personal injuries. -
Page 5: Additional Specific Safety Rules
English into account the working conditions and the these chemicals: work in a well ventilated area, and work with work to be performed. Use of the power tool for approved safety equipment, such as those dust masks that are operations different from those intended could result specially designed to filter out microscopic particles. -
Page 6: Intended Use
English Side Handle (Fig. A) The label on your tool may include the following symbols. The symbols and their definitions are as follows: WARNING: To reduce the risk of personal injury, V ......volts or AC ... alternating current ALWAYS operate the tool with the side handle Hz ....... -
Page 7: Operation
English Forward/Reverse Button Fig. D The forward/reverse button is used to reverse the hammerdrill for backing out screws or jammed bits. It is located above the trigger, shown in Figure B. To reverse the hammerdrill, turn it off and push the reversing lever to the hAMMER DRill left (when viewed from the chuck end). -
Page 8: Maintenance
English Drilling Drilling in Masonry When drilling in masonry, use carbide tipped bits rated WARNING: To reduce the risk of personal injury, for percussion drilling and be certain that the bit is sharp. ALWAYS ensure workpiece is anchored or clamped For holes up to 3/8"... -
Page 9: Protecting The Environment
English MAXIMUM RECOMMENDED CAPACITIES DW505 Chuck capacity 1/2" (13 mm) R.P.M 0–1270 – 0–3000 Bits, metal drilling 1/2" (13 mm) low speed Wood, flat boring 1–1/2" (38 mm) low speed Bits, masonry drilling 3/4" (19 mm) soft materials Hole saws 2–1/8"... - Page 12 Made in Brazil WALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286 (Mar17) Part No. N482746 DW505 Copyright © 2003, 2006, 2011, 2017 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme, the “D” shaped air intake grill, the array of pyramids on the handgrip, the kit box configuration, and the array of lozenge-shaped humps on the surface of the tool.