Table of Contents
Advertisement
Quick Links
TESHC03E
Induction& Electric Cooktop
Installation Instructions
User Guide
and
Contents
1．
Safety and warnings
2．
Installation instructions
3．
Introduction
4．
Using your cooktop
5．
Choosing the right cookware
6．
Cooking guidelines
7．
Care and cleaning
8．
Troubleshooting
9．
Warranty and service
Important!
SAVE THESE INSTRUCTIONS
The models shown in this user guide may not be available in all markets and are
subject to change at any time. For current details about model and specification
availability in your country, please visit our local website listed on the back cover
or contact your local dealer.
1
1．Safety and Warnings
Your safety is important to us. Please read this information before using your cooktop.
Installation
Electrical Shock Hazard
1.
Disconnect the appliance from the mains electricity supply before carrying
out any work or maintenance on it.
2.
Connection to a good earth wiring system is essential and mandatory.
3.
Alterations to the domestic wiring system must only be made by a
qualified electrician.
4.
Failure to follow this advice may result in electrical shock or death.
Cut Hazard
1.
Take care - panel edges are sharp.
2.
Failure to use caution could result in injury or cuts.
Important safety instructions
1.
Read these instructions carefully before installing or using this appliance.
2.
No combustible material or products should be placed on this appliance at any
time.
3.
Please make this information available to the person responsible for installing
the appliance as itcould reduce your installation costs.
4.
In order to avoid a hazard, this appliance must be installed according to these
instructions for installation.
5.
This appliance is to be properly installed and earthed only by a suitably
qualified person.
6.
This appliance should be connected to a circuit which incorporates an
isolating switch providing full disconnection from the power supply.
7.
Failure to install the appliance correctly could invalidate any warranty or
liability claims.
Operation and Maintenance
Electrical Shock Hazard
1.
Do not cook on a broken or cracked cooktop. If the cooktop surface should break or
crack, switch the appliance off immediately at the mains power supply (wall switch)
and contact a qualified technician.
2.
Switch the cooktop off at the wall before cleaning or maintenance.
3.
Failure to follow this advice may result in electrical shock or death.
Fire Hazard（Electric Cooking Zone）
1.
Never leave the appliance unattended when in use. Boilover causes smoking and
greasy spillovers that may ignite.
2.
Never use your appliance for warming or heating the room.
3.
Failure to follow this advice may result in overheating, burning, and injury.
Advertisement
Table of Contents
Related Manuals for Nebula TESHC03E
Summary of Contents for Nebula TESHC03E
-
Page 1: Installation Instructions
1．Safety and Warnings TESHC03E Your safety is important to us. Please read this information before using your cooktop. Induction& Electric Cooktop Installation Installation Instructions Electrical Shock Hazard Disconnect the appliance from the mains electricity supply before carrying User Guide out any work or maintenance on it. - Page 2 use. Health Hazard This appliance complies with electromagnetic safety standards. However, persons with Children or persons with a disability which limits their ability to use the cardiac pacemakers or other electrical implants (such as insulin pumps) must consult with appliance should have a responsible and competent person to instruct them in its use.
- Page 3 Installation instructions Turn the cooktop upside down and place it on a soft surface. Spread the seal around the edges of the ceramic glass with the adhesive side facing down, making sure that the whole perimeter is sealed. Cut off any excess material. Place the cooktop into the cutout, using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop.
- Page 4 Fig. 1 Thermal Protection Barrier The thermal protection barrier must be: Removable heat-resistant made from low thermal conductivity material at least 25 mm below the plastic housing of the cooktop chassis Connecting the Cooktop to the Mains Power Supply Important! A minimum clearance from rear edge of cutout to nearest combustible surface: 55 This cooktop must be connected to the mains power supply only by a B minimum clearance from glass surface to rangehood: 650...
-
Page 5: Final Checklist
alterations. Any alterations must only be made by a qualified electrician. Is the cooktop fixed securely? Check that the pan detection feature is working correctly. Turn on each cooking ？ zone without putting any cookware on them. Are all the displays flashing Check that all the cooking zones function correctly. -
Page 6: Using Your Cooktop
Use is safer as no heating takes place unless a suitable pan is placed on the Control Keys cooking zone. As heat is transferred without loss, you save energy. Before using your new cooktop Read this guide, taking special note of the ‘Safety and warnings’ section. Remove any protective film that may still be on your cooktop. - Page 7 Make sure that the base of your pan is smooth, sits flat against the glass, and is the same size as the cooking zone. Always centre your pan on the cooking zone. Adjust heating power Sliding touch the power and timer setting range to increase or decrease the heating power.
- Page 8 Metallic stains on glass caused by cookware with copper base aluminium base How? Important ： Follow the instructions for ‘Nonsugary boilovers, spills and food stains on glass’ above. ‘ ’ When the power to the cooktop is switched off, there will be no hot surface For stubborn metallic stains, try using a razor blade scraper suitable for ceramic glass indication but the cooking zone may still be hot! Take extreme care.
- Page 9 Problem ： This is caused by the technology of induction cooking. The touch controls are unresponsive. What to do This is normal, but the noise should quieten down or disappear completely when you Possible causes decrease the heat setting. The controls are locked. What to do Unlock the controls.
-
Page 10: Warranty And Service
Allow the cooktop to cool down. Model: Problem ： zone has turned itself off unexpectedly, a tone sounds and an error code is displayed Date of Purchase Purchaser (typically alternating with one or two digits in the cooking zone Dealer displays).