Philips SBC RU422 Instructions For Use Manual page 4

RU240- page 4
3 Immediately press
If you missed the correct code because the search went too far, switch
the equipment back on, then press
code again. Press
off again.
4 Once you've found the correct code, press
The green LED blinks twice.
That's it! Now, switch the equipment manually on again, then press a
few keys on the remote to check that the equipment responds correctly.
In the rare instance that it doesn't, try again from step 1 to find a better
code.
Note that code! To save time if you ever need to setup again, make a
note of the correct code inside the battery case and in the back of this
booklet. In case you have forgotten to note the code you can still 'read
out' the code from the remote. Here's how:
1 Make sure you've selected the right mode (with
and release
1
2 Press . The green LED goes out.
3 Press 1 and count the number of times the green LED blinks. This
is the first digit of the 3-digit code. (No blinks means the digit is
zero.)
Press 2 and count the number of blinks for the second digit.
Press and count the number of blinks for the third digit.
3
4
to stop the search.
P
(down) repeatedly until the equipment switches
P
and at the same time; the green LED lights up.
6
(down) to send the previous
to lock it in memory.
). Then press