Philips/Magnavox CCX133AT Owner's Manual page 37

Setting Up the VCR Plus+ Programming System (cont'd) 37
2
Now, compare the channel numbers you have written in the VCR
PLUS+ CH. and CABLE/TV CH. columns. You'll notice that some
stations have VCR Plus+ and Cable/TV channel numbers that are
the same, and other stations have channel numbers that do not
match. Where the channel numbers DO NOT match, you must
tell the TV/VCR the VCR Plus+ and Cable/TV channel numbers
according to the following steps.
Make each entry within 60 seconds of the previous entry.
3
Press the MENU button to display the pop up menu.
4
Press the PLAY/ button or the STOP/
VCR SETUP, then press the F.FWD/+ button.
VCR SETUP
1 ONE TIME PLAY [ON]
2 REPEAT PLAY
3 ON-SCREEN MODE
4 RECORD DEFEAT [OFF]
5 VCR PLUS+ REF. MAP
TO SELECT PRESS NUMBER
TO END PRESS EXIT
5
Press the Number 5 button to select VCR PLUS+ REF. MAP.
VCR PLUS+ CROSS REF. MAP
VCR PLUS+ CABLE/TV
124 – –
125 – –
01 – – – – – –
B
02 – –
03 – –
TO SELECT CH PRESS CH /
THEN ENTER CH NO.
TO END PRESS EXIT
6
Look at the lists you filled in on page 36. For stations whose
VCR Plus+ and Cable/TV channels do not match, press
the CHANNEL (Up/Down) buttons until the arrow is
beside the VCR Plus+ channel you need. Then, press the
Number buttons to enter the corresponding Cable/TV
channel from your list. (Enter a "0" before single-digit chan-
nels.) Continue this process until you have entered all the stations
on your list.
VCR PLUS+ CROSS REF. MAP
VCR PLUS+ CABLE/TV
124 – –
125 – –
01 – – – – 23
B
02 – –
03 – –
TO SELECT CH PRESS CH /
TO DELETE PRESS CLEAR
TO END PRESS EXIT
7
Press the STATUS/EXIT button to exit.
2
6
5
4
button to select
3
• To correct a Cable/TV channel num-
• To clear a Cable/TV channel number,
• Always enter a "0" before single-
• To select line input for the Cable/TV
Examine the lists on
page 36.
2 3
1
5 6
4
o
8 9
7
p
0
+100
o
p
o
PLAY
– REW F.FWD
STOP
p
Helpful Hints
ber, repeat the steps on this page.
repeat steps 3-5 on this page. Then,
press the CHANNEL (Up/Down) but-
tons to select it. Then press the
CLEAR button. Press the
STATUS/EXIT button to exit.
digit channels.
channel, press 0,0. A/V IN will
appear on-screen.
+
7