Adjusting Air Flow Direction; Reglage Du Sens De Diffusion De L'air - Toshiba RB-B11MCWE Owner's Manual

ADJUSTING AIR FLOW DIRECTION

• Adjust the air flow direction properly. Failure to do so could cause discomfort and
cause uneven distribution of room temperature.
• When the air conditioner stops, the louver (adjustment plate of up/down air flow
direction) directs upward automatically.
• In heating operation, when starting the operation/executing defrost operation or when
the room temperature has reached the required set temperature, the fan stops or the
air flow is vastly reduced and the louver directs upward.
During this time, even if the SWING button or the FIX button are pushed, the louver
does not move as it directs upward. When starting the usual heating operation which
blows hot air, the louver directs towards the set air flow direction.
Adjusting the air flow direction
The air conditioner automatically adjusts the air flow direction according to the operating
conditions when AUTO or A mode is selected.
To set a selected air flow direction
Use this function when the air conditioner is operating.
a FIX button
Hold down or briefly push the FIX button on the remote controller to move the louver
to the desired direction.
• Change the air flow louver direction within the range that is displayed.
• In subsequent operations, the air flow is automatically set to the direction that you
set the louver using the FIX button.
In HEAT/FAN ONLY operation
In STOP mode
Louver operating range in
HEAT/FAN ONLY mode
To automatically swing the air flow direction
Perform this function when the air conditioner is operating.
a SWING button
Push the SWING button on the remote controller.
• To stop the function, push the SWING button.
• To change the swinging direction, push the FIX button.
• In COOL/DRY operation, the louver does not stop as it directs downward. If stopping the
louver as it directs downward during swing operation, it stops after moving for a small
duration.
CAUTION
• The FIX and SWING buttons will be disabled when the air conditioner is not operating
(including when the ON TIMER is set).
• Do not operate the air conditioner for an extended period of time with the air flow
direction set downward during the cooling or drying operation: otherwise
condensation may occur on the surface of the air flow louver and cause water
dripping.
• Do not move the air flow louver manually. Always use the FIX button.
If you move the louver manually, it may malfunction during operation.
If the louver malfunctions, stop the air conditioner, and restart it.
• When the air conditioner is started immediately after it was stopped, the air flow
louver may not move for about 10 seconds.
EN
AMP Air Conditioning
In COOL/DRY operation
In STOP mode
Louver operating range in
COOL/DRY mode
Louver does not direct downward in
COOL/DRY mode.
16
www.ampair.co.uk | sales@ampair.co.uk
In all modes
In STOP mode
Louver swing range in all
operating modes