Weather Station Assembly - Campbell 012 Operator's Manual

SECTION 2. WEATHER STATION INSTALLATION

2.4 WEATHER STATION ASSEMBLY

The following instructions describe the
installation of the 012 weather station. All steps
except those marked with an asterisk (*) are
shown in Figure 2.4-1.
Before assembling the threaded ends of the
mast, apply the teflon pipe dope provided with
the weather station to prevent the aluminum
from galling.
2-4
FIGURE 2.4-1. 012 Weather Station Assembly
Step 1  Thread the cables from the canister
through the mast and hand tighten the mast to
the canister. Do not twist the cables.
Step 2.  Remove the crossarm cover.
Thread the cables through the center hole of
the crossarm and screw the crossarm to the
mast.