Electrical Adjustment Instructions - Sylvania 6319CCB Service Manual

ELECTRICAL ADJUSTMENT INSTRUCTIONS

General Note:
"CBA" is abbreviation for " Circuit Board
Assembly."
NOTE:
Electrical adjustments are required after replacing
circuit components and certain mechanical parts.
It is important to perform these adjustments only
after all repairs and replacements have been com-
pleted.
Also, do not attempt these adjustments unless the
proper equipment is available.
Test Equipment Required
1. NTSC Pattern Generator (Color Bar W/White Win-
dow, Red Color,
Scale, Monoscope, Multi-Burst)
2. AC Milli Voltmeter (RMS)
3. Alignment Tape (FL8A, FL8N), Blank Tape
4. DC Voltmeter
5. Oscilloscope: Dual-trace with 10:1 probe,
V-Range: 0.001~50V/Div,
F-Range: DC~AC-60MHz
6. Frequency Counter
7. Plastic Tip Driver
How to make service remote control unit:
1. Prepare normal remote control unit. (Part No. N0107UD)
Remove 3 screws from the back lid. (Fig. 1-1)
2. Added J1 (Jumper Wire) to the remote control CBA.
(Fig. 1-2)
Remote control unit (Bottom)
Remote control CBA
Dot Pattern, Gray
Fig. 1-1
Fig. 1-2
How to Set up the Service mode:
Service Mode:
1. Use the service remote control unit.
2. Turn the power on.
3. Press " WAKE-UP/SLEEP " button on the service
remote control unit.
1. DC 114V (+B) Adjustment
Purpose: To obtain correct operation.
Symptom of Misadjustment: The picture is dark and
unit does not operate correctly.
Test Point Adjustment Point
J261
(+B)
J281
(GND)
Tape
--- DC Voltmeter
Note: J261(+B), J281(GND), VR601 --- Main CBA
1. Connect the unit to AC Power Outlet.
2. Connect DC Volt Meter to J261(+B) and J281(GND).
3. Adjust VR601 so that the voltage of J261(+B) be-
comes +114±0.5V DC. (A)
2. Auto AFT (VCO) Adjustment
Purpose: To operate AFT correctly.
Symptom of Misadjustment: AFT does not work cor-
rectly and/or synchronization is faulty.
Test Point Adjustment Point
---
Tape
---
1. Set the unit to the VIDEO mode with no signal input.
2. Enter the Service mode. (See page 1-4-1) Then
press number "3" button on the remote control unit.
3. If the screen color changes to "Green" then this
adjustment is finished.
4. If the screen color changes to "Red" then this adjust-
ment is failed. Repeat steps 1 and 2 or check relative
circuit or parts (IC).
1-7-1
Mode
VR601 ---
M. EQ. Spec.
+114±0.5V DC
Mode
--- VIDEO
M. EQ. Spec.
---
Input
---
Input
---
---
T7200EA