Configuring Mac Addresses For A Do1X Profile; Configuring The Static Mab And Mab Profile - Dell S6100 Configuration Manual

dot1x profile {profile-name}
profile—name — Enter the dot1x profile name. The profile name length is limited to 32 characters.
Example of Configuring and Displaying a dot1x Profile
Dell(conf)#dot1x profile test
Dell(conf-dot1x-profile)#
Dell#show dot1x profile
802.1x profile information
-----------------------------
Dot1x Profile test
Profile MACs
00:00:00:00:01:11

Configuring MAC addresses for a do1x Profile

To configure a list of MAC addresses for a dot1x profile, use the mac command. You can configure 1 to 6 MAC addresses.
• Configure a list of MAC addresses for a dot1x profile.
DOT1X PROFILE CONFIG (conf-dot1x-profile)
mac mac-address
mac-address — Enter the keyword mac and type up to the 48– bit MAC addresses using the nn:nn:nn:nn:nn:nn format. A maximum
of 6 MAC addresses are allowed.
Example of Configuring a List of MAC Addresses for a dot1x Profile
The following example configures 2 MAC addresses and then displays these addresses.
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile sample
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit
Dell(conf)#

Configuring the Static MAB and MAB Profile

Enable MAB (mac-auth-bypass) before using the dot1x static-mab command to enable static mab.
To enable static MAB and configure a static MAB profile, use the following commands.
• Configure static MAB and static MAB profile on dot1x interface.
INTERFACE mode
dot1x static-mab profile profile-name
Eenter a name to configure the static MAB profile name. The profile name length is limited to a maximum of 32 characters.
Example of Static MAB and MAB Profile for an Interface
Dell(conf-if-Te-2/1)#dot1x static-mab profile sample
Dell(conf-if-Te 2/1))#show config
!
interface TenGigabitEthernet 21
switchport
dot1x static-mab profile sample
no shutdown
90 802.1X