Kenmore 795.69292.902 Service Manual page 10

• At this point, remove the Decorative Bolt on bottom on
refrigerator housing from the left side of refrigerator
(Fig. 24). You will need this hole for the Bottom Hinge.
Fig. 24
• Move the Bottom Hinge to the left side of housing keeping
the same orientation, and reattach with 3 bolts (Fig. 25).
Now move Decorative Bolt to hole on lower right side
of housing.
Fig. 25
• Turn refrigerator door upside down on a non-scratching
surface.
• With door upside down, loosen the 2 screws and remove the
Door Closer/Stop (Fig. 26), then loosen the other two screws to
remove the bottom Hinge Pin Insert Bracket with Hinge Pin
Insert (see Fig. 27).
NOTE: The Refrigerator Door Closer/Stop is not used on all
models. The model you have may not include this part.
Fig. 26
Fig. 27
Hinge
Pin Bracket
Hinge Pin
Insert
Door Closer/Stop
- 10 -
• Take out the Hinge Pin Insert and move the Bracket to the
other side of the door,keeping the same orientation (Fig. 28).
• Place Hinge Pin Insert into the left side
of the bracket. Tighten Hinge Pin Bracket
to door (Fig. 28).
• Take Door Closer/stop and flip (see Fig. 29). Line up screw
holes and mount on left side of door bottom with the two
screws. Turn door upright. It is now ready for re-attaching.
NOTE: The Refrigerator Door Closer/Stop is not used on all
models. The model you have may not include this part.
Fig. 29
• With flat-head screwdriver, carefully pry off and remove the
cover over the screw holes on the left side of refrigerator
housing (Fig. 30).
Fig. 30
• Remove the outer lower Decorative Screw from housing
at area between freezer and refrigerator doors (Fig. 31).
(You will need this hole for the Middle Hinge Bracket).
Fig. 31
Fig. 28
Hinge
Pin Bracket
Hinge Pin Insert