Whirlpool R1011 Installation Instructions And Use & Care Manual page 4

Electrical Requirements
Continued
115 volt models with amperes
-
up through 12.0
Receptacle wiring
Receptacle wiring should be a minimum of
14 gauge. Use copper wire only. It is the respon-
sibility of the consumer to provide proper and
adequate receptacle wiring, installed by a
qualified electrician. Observe National Electrical
Code and all local governing codes and ordi-
nances.
Electrical requirements
A 115 volt (103.5 min., 126.5 max.), 60 Hz, AC
only, 15 ampere fused electrical supply is
required (time delay fuse or time delay circuit
breaker required). For models with serial plate
amperes of 7.6 through 12, it is required that a
separate circuit, serving only this appliance, be
provided.
Electrical connection
II
Electrical ground is required on this appliance.
Recommended grounding method:
3prong
For your personal safety, this appliance must be
grounding
grounded. This air conditioner is equipped with a
Plug
%v-
8
!'
power supply cord having a 3-prong grounding
prong. To minimize possible shock hazard, the
cord must be plugged into a mating 3-prong
Grounding
grounding type wall receptacle, grounded in
prong
4
3prong
accordance with the National Electrical Code and
grounding
type wall
local codes and ordinances. If a mating wall
receptacle
receptacle is not available, it is the responsibility
of the customer to have a properly grounded
Power
W$lY
3-prong wall receptacle installed by a qualified
electrician.