Table of Contents
Advertisement
17. Source
Select input source.
Combo key function for Remote Control
ID settings (Press ID button + Number for
3 seconds).
18. Auto / 0
This button is used to Resync the picture;
when the picture signal becomes unstable
or picture quality deteriorates simply
press this button and the projector will
automatically adjust the screen dimension,
phase, timing and so forth.
Number for Remote ID setting used.
19. Brightness
Displays the brightness setting bar.
20. Contrast / 2
Displays the Contrast settings bar.
Number for Remote ID setting used.
21. Light
Displays the light power adjustment menu.
22. Zoom / 4
Displays the digital zoom settings bar.
Number for Remote ID setting used.
23. Freeze
Freeze/unfreeze the picture on the screen.
24. Blank / 6
Makes the screen blank.
Number for Remote ID setting used.
25. STANDBY
This button is used to turn off the
projector.
26. Video / S-Video
Displays the Video source selection.
27. Network
Open the Network menu.
28. EXIT
Press this button to exit menu or return to
previous menu level.
29. ► /
Use this button to make your selection
or configure, adjust configuration on the
menu.
Keystone can be adjusted when no other
menu is displayed.
30. MHL
Change MHL / Projector mode.
31.
Play the following item on the
programming list for MHL.
32.
Forward in set increments for MHL.
33. Volume / 1
Displays the Volume setting bar.
Number for Remote ID setting used.
34. Mute /3
Mutes the built-in speaker.
Number for Remote ID setting used.
35. 3D / 5
Open the 3D Setting menu.
Number for Remote ID setting used.
36. Status / 7
Opens the Status menu (the menu only
opens when an input device is detected).
Number for Remote ID setting used.
37. Wire jack
Connect wire remote to the projector.
Note:
Remote Combo Key Settings:
ID+0: Reset Remote Control ID to
default settings.
ID+1: Set Remote Control ID to "1".
~
ID+7: Set Remote Control ID to "7".
Projector also need setting ID for
unique control. Refer to CD Page 67 :
"Remote ID".
Note: When the projector is under MHL
mode, the keypad on projector should
be same definition of the key on
remote control.
With MHL function:
MENU for App settings, ▲ Up, ▼
Down, ◄ Left and ► Right are used
as directional arrows, also included
ENTER and EXIT.
Controlling your smart device with
the remote control:
When the projector displays the
content from your MHL compatible
smart device, you can use the remote
control to control your smart device.
To enter the MHL mode, the
following buttons are available for
controlling your smart device, Arrow
keys (▲ Up, ▼ Down, ◄ Left, ►
Right), MENU, EXIT, MHL control
buttons.
Remote control
English-23
Advertisement
Table of Contents
