Configuring Snmp For Trill; Configuring Trill Gr - HP 6125XLG Trill Configuration Manual

Step
1. Enter system view.
2. Enter TRILL view.
3. Enable logging of TRILL
neighbor changes.

Configuring SNMP for TRILL

After you enable SNMP notification sending for TRILL, TRILL will generate notifications to notify NMS of
important events on the local module and send the notifications to the SNMP module. You can set the
notification sending parameters in SNMP. For more information about notifications, see Network
Management and Monitoring Configuration Guide.
TRILL uses the IS-IS MIB to provide the TRILL object management function for NMS. Because the MIB
objects defined in the IS-IS MIB are single-instance management objects, NMS cannot manage IS-IS and
TRILL at the same time. According to the management for multiple OSPF instances defined in RFC 4750,
you can set a context name for the SNMP object for managing TRILL. In this way, the SNMP requests for
managing IS-IS and the SNMP requests for managing TRILL from NMS can be distinguished. Because the
context name is a concept specific to SNMPv3, the community names are mapped to context names for
distinguishing different protocols in SNMPv1/v2c.
To configure SNMP for TRILL:
Step
1. Enter system view.
2. Enable SNMP
notification sending
for TRILL.
3. Enter TRILL view.
4. Configure the context
name for the SNMP
object for managing
TRILL.

Configuring TRILL GR

Graceful Restart (GR) ensures the continuity of packet forwarding when a protocol restarts or an
active/standby switchover occurs. The device on which a protocol restarts or an active/standby
switchover occurs advertises the restart status to the neighbors, and allows the neighbors to re-establish
connections. GR involves the following roles:
GR restarter—Graceful restarting router. It must be GR capable.
•
Command
system-view
trill
log-peer-change enable
Command
system-view
snmp-agent trap enable trill
[ adjacency-state-change | area-mismatch |
buffsize-mismatch | id-length-mismatch |
lsdboverload-state-change | lsp-parse-error |
lsp-size-exceeded | max-seq-exceeded |
maxarea-mismatch | new-drb | own-lsp-purge
| protocol-support | rejected-adjacency |
skip-sequence-number | topology-change |
version-skew ] *
trill
snmp context-name context-name
15
Remarks
N/A
N/A
By default, logging of TRILL neighbor changes
is enabled.
Remarks
N/A
By default, SNMP
notification sending is
enabled for TRILL.
N/A
By default, no context name
is set for the SNMP object for
managing TRILL.